Induction hot heating PLC system pipe bending machine
Production range:OD60mm-2000mm(2-80inches)
Radius:2.5 D ≤ R ≤ 10D ≤ 15000mm.
Thickness:2-90mm.
Angle:0-180 degree
Bending material: Carbon steel, alloy steel, stainless steel.
Operate way: Manual, PLC.
Suitable environment for Induction hot heating PLC system pipe bending machine:
Temperature -5-45℃,reversely humidity≤80%, input voltage is three
phase four line 380V( -10% — +15%),Frequency 50Hz±2%,working time
8-24 hours/day, No corrosive media, enough running space without
wind and rain.
Our Induction hot heating PLC system pipe bending machine has following advantages:
1. Main body is strength and durable.
2. Underframe welded with structural steel and steel plate, and
machine milling. Pushing plate using T type groove structure,
travel smoothly. Under the push board with grey iron plate,
wear-resisting. Have wear compensation regulating variable.
3. Bending radius is adjusted by cycloidal motor drive screw rod
adjustment, convenient adjustment, high precision.
4. Hydraulic system uses frequency control, working speed stepless
variable speed, convenient adjustment, improve the production
efficiency, saving energy save electricity. According to the
feeding speed control motor speed, adjust the fuel delivery
accordingly, on-demand oil supply, hydraulic oil without high
pressure unloading, the oil temperature not too high.
5. Rocker arm uses the center boom structure, overcome the twist of
rocker by bend moment, high bending precision, small rotating
resistance, especially suitable for thin wall tube bending.
6. Medium frequency power supply adopts zero pressure startup mode,
high success rate, high heating efficiency, low failure rate. Using
control device, make power output stability: Input line voltage
fluctuation ±15%, the system also can ensure constant power output.
