Horizontal Cnc Full Automatic Metal Cutting Band Sawing Machine
The friends who buy Huntsman horizontal band sawing machine
products should strictly follow the following procedures:
1. Before operation, it is required to wear tight protective
clothing, fasten the cuff, keep the lower part of the coat closed,
and never wear gloves. It is not allowed to wear, take off or
change clothes next to the moving machine tool, or wrap the cloth
on the body to prevent the machine from being twisted. Safety
helmet must be worn, braids should be put into the hat, and skirts
and slippers are not allowed. A kind of
2. Make all preparations before starting the machine. Install the
vise so that the sawing center is in the middle of the sawing
stroke. The raw materials are placed horizontally on the vise and
at right angles to the saw blade; if it is necessary to saw the
bevel angle, first adjust the vise to the required angle, and the
saw size shall not be greater than the maximum saw size of the
machine tool. A kind of
3. The huntsman saw blade must be tensioned. Before sawing, the
test run shall be idle for 3-5 minutes to blow out the air in the
hydraulic cylinder and the oil grooves on the hydraulic
transmission device, and check whether the sawing machine has any
fault and the lubricating oil circuit is normal.
4. When sawing pipe or sheet section at the top, the tooth pitch
shall not be less than the thickness of the material. When sawing,
the handle should be back to the slow position and the feed amount
should be reduced. A kind of
5. During the operation of the sawing machine, it is not allowed to
change speed halfway. The sawing materials shall be placed, clamped
and clamped firmly. The feed amount shall be determined according
to the hardness of the material and the quality of the saw blade. A
kind of
6. Special hydraulic oil and lubricating oil must be used in the
hydraulic transmission and lubricating device. The coolant must be
clean and replaced or filtered periodically.
| Type | GZ 4235 |
| Cut capcity W*H (mm) | round 350 |
| square 350*400 |
| Bundle cutting W*H (mm) | Max.350*230 |
| Min.200*20 |
| Saw belt size(mm) | 4220*34*1.1 |
| belt line speed(m/min) | 40/60/80 |
| Main generator power(kw) | 3 |
| Hydraulic generator power(kw) | 0.75 |
| Cooling generator power (kw) | 0.09 |
| Working clamp style | Hydraulic |
| Saw belt tighten style | Hand |
| Main transmit structure | Turbine |
| Loading style | Extra roller |
| Packing dimensions(mm) L*M*H | 2100*110*1500 |
| Weights of machine (kgs) | 1970 |
