Metal Cutting Horizontal Electric Control Band Saw Machine

The friends who buy Huntsman horizontal band sawing machine products should strictly follow the following procedures:
1. Before operation, it is required to wear tight protective clothing, fasten the cuff, keep the lower part of the coat closed, and never wear gloves. It is not allowed to wear, take off or change clothes next to the moving machine tool, or wrap the cloth on the body to prevent the machine from being twisted. Safety helmet must be worn, braids should be put into the hat, and skirts and slippers are not allowed. A kind of
2. Make all preparations before starting the machine. Install the vise so that the sawing center is in the middle of the sawing stroke. The raw materials are placed horizontally on the vise and at right angles to the saw blade; if it is necessary to saw the bevel angle, first adjust the vise to the required angle, and the saw size shall not be greater than the maximum saw size of the machine tool. A kind of
3. The huntsman saw blade must be tensioned. Before sawing, the test run shall be idle for 3-5 minutes to blow out the air in the hydraulic cylinder and the oil grooves on the hydraulic transmission device, and check whether the sawing machine has any fault and the lubricating oil circuit is normal. 4. When sawing pipe or sheet section at the top, the tooth pitch shall not be less than the thickness of the material. When sawing, the handle should be back to the slow position and the feed amount should be reduced. A kind of
5. During the operation of the sawing machine, it is not allowed to change speed halfway. The sawing materials shall be placed, clamped and clamped firmly. The feed amount shall be determined according to the hardness of the material and the quality of the saw blade. A kind of

Hei Yan Group Covers the following R&D abilities :

1. PLC induction pipe bending machine,
2. Cold forming tee machine
3. Automatic Hot forming elbow machine
4. hydraulic pipe expanding machine
5. Bevel machine
6. Hydraulic press machine.
7. Cold elbow forming machine
8. Bandsaw machine
9. Medium Frequency power source
10. Shot Blast Machine
11. Pipe fittings dies&mandrels
12. Steel pipe fittings